Hi,
I decided it was time to speed up the boot time of my machine and Separate Windows and data by adding a new SSD. I purchased a Crucial MX100 256Gb SSD and connected it via one of the Intel SATA ports (SATA 2-0) but after cloning my current hard drive using the included Acronis True Image software I found on reboot that my crucial SSD did not appear.
I believe that I should use SATA 2-0 as that is the only port that supports AHCI mode. However after configuring AHCI mode in the bios (which I also upgraded to F9 from F2) my machine would just keep rebooting. I set back to IDE and my machine works fine but dont see the SSD Drive.
Can anyone help? I read from another post that I need to install latest Intel RST drivers but when I look on the Intel download page it lists a number of controllers which are supported and to be honest I am not sure which mine is.
My spec is:
Gigabyte P55-UD4 Rev1.0
Win7 Home Edition 64 bit
4GB Dual-channel Corsair DDR3
ATI Radeon HD 4650 Graphics
Samsung 80GB (boot) + Maxtor 80GB + Seagate 160GB
I dont want to wast time installing newer drivers if the problem is simpler to solve.
Thanks
JC