Questions about GIGABYTE products > X99 Motherboards

GA-X99-UD4 may hang on boot ...

<< < (2/2)

computermensch:
It seems to be when the UEFI:NIC is registered somewhere in the boot sequence (and with a lower precendece than the disk ... i.e. coming after the ssd with the system part) that the boot sequence may hang (block).

So as a temporary solution - after you have used UEFI:NIC PXE IP4 / UEFI:NIC PXE IP6 + SSDD (Windows Boot Manager) in the boot sequence to i.e. deploy the os from a network service ...

... then remove UEFI:NIC IP4 + UEFI:NIC IP6 from the boot sequence in the BIOS.
That seems to fix it.

BTW Still needs to be fixed in the firmware ...

dmdilks:

--- Quote from: computermensch on September 12, 2014, 09:31:12 am ---BTW Still needs to be fixed in the firmware ...

--- End quote ---

Yes they need to fix but for windows 8. They are trying really hard to fix that too. But what I see is they make one step forward and than two or three steps back.

Just hold on they have a new OS coming maybe by the end of this year or early next year. To replace windows 8 & 8.1 So you can throw that in to the mix as well.

computermensch:
Just to completely close this thread - in my case it was the unrealiable boot too that has just been corrected with a BIOS update (referred to in other posts in this forum as the boot loop). BTW I also had the HOTAS Warthog connected to the system.

Navigation

[0] Message Index

[*] Previous page