Questions about GIGABYTE products > X99 Motherboards

GA-X99-UD4 can't go to bios setup

(1/5) > >>

lisboa:
Please can some one help me!! It boots with no problem in the windows 8 but when I try enter bios setup in a cold boot it freezes in a blank screen. So I disconnected all sata hard disk and it goes to bios. What is happening with Gigabyte boards?

dmdilks:
It might be windows 8 causing the problem. Because windows 8 uses UEFI and it will boot really fast.

Try to just disconnect the drive that has windows 8 on it and see what happens. All I can say is update the bios.

All of the X99 boards are having problems. I have the same board and so far I have not had any problems.

But again I'm not running or will not run windows 8. Plus I'm a Microsoft Partner too.

 

lisboa:

--- Quote from: dmdilks on November 23, 2014, 11:45:26 pm ---It might be windows 8 causing the problem. Because windows 8 uses UEFI and it will boot really fast.

Try to just disconnect the drive that has windows 8 on it and see what happens. All I can say is update the bios.

All of the X99 boards are having problems. I have the same board and so far I have not had any problems.

But again I'm not running or will not run windows 8. Plus I'm a Microsoft Partner too.

--- End quote ---

If I disconnect the driver that has windows 8 it will go to Bios. But it should not be like that.

dmdilks:
It could be that drive that is causing the problem. I have had brand new drive that are bad. Do you have another drive that you can install windows on and see what happens.

Extradry:

--- Quote from: dmdilks on December 03, 2014, 03:29:46 pm ---It could be that drive that is causing the problem. I have had brand new drive that are bad. Do you have another drive that you can install windows on and see what happens.

--- End quote ---

I have the exact same problem on the same board (Win7 btw). All drives work properly. It will boot up into windows with all drives available, but as soon as i try and enter the bios(updated to F9) it will just hang there with a blank screen. I have tried each drive individually with the same issue (2 SSD 2 SATA 3.5'). Anyhow i will try a few different settings in the bios when i get a chance just really annoying having to disconnect all the drives eveytime I enter the bios.

Navigation

[0] Message Index

[#] Next page