Sure. I have the same CPU, it supports what your configuration. Basically what you want to do is get the system to run with one, then two installed sticks.
First test, set XMP with one stick installed, see if it will boot after installing the second stick. The goal is achieving 2133 without further intervention.
If this doesn't work, you might have to try setting timing and voltages manually in M.I.T.
9-9-9-24 @1.5v should run at 1333/1600
10-11-11-31 @1.5 should run at 2133 < this setting might require a slight OC on the CPU as this is above native FSB speed.
Other option, try BIOS F6 (if not already done with this RAM).
i try your setting, but don't work in any mode, system start good with 1 bank i set xmp, save, shutdown, insert second bank and system don't start ..... shut down remove 1 bank and restart set multiplier on advanced manual mode to 10-11-11-31 at 21.33, save, restart and system work good, but insert second bank system don't start
I think 2 slots do not work .... the first 2 slots those towards the atx cable one gray and one black also work individually, while the other 2 slots one gray and one black singly, inserting only one desk in one of these slots, the system does not start
try to reflash F7 bios but not change situation ....not possible to flash F6 bio because have bios protection downgrade
