Questions about GIGABYTE products > Motherboards with Intel processors

ME_RCVR (ME Recovery Jumpers)

(1/2) > >>

toomanylogins:
I am trying to revert the BMC firmware on my MU-70 motherboard to defualt. Does anybody know what this jumper does before I try it. 

ME_RCVR (ME Recovery Jumpers)

There is no description in the manual of what ME Recovery means ?
Thanks
Paul

shadowsports:

--- Quote from: toomanylogins on March 19, 2020, 10:36:31 am ---I am trying to revert the BMC firmware on my MU-70 motherboard to defualt. Does anybody know what this jumper does before I try it. 

ME_RCVR (ME Recovery Jumpers)

There is no description in the manual of what ME Recovery means ?
Thanks
Paul

--- End quote ---

Greetings,
I thought you were going to contact support regarding the BMC and lack of function after upgrade to R10.  What every happened?

There is nothing in the product manual beyond location of the jumpers above the second PCIEx slot.  They are for the Intel ME, but nothing about what happens when they are enabled.  Documentation is lacking.  57 is listed as a LED in the manual …  57 LED_BMC1 BMC firmware readiness LED - Page 8 , but its obviously a slot.  You really need to engage support.



https://www.gigabyte.com/Press/News/1582




   

toomanylogins:
Hello,

Thanks for the reply.  I posted a support request a week ago but no reply for obvious reasons.  Managed to work out that this jumper is for the Intel Management engine so it's unrelated to the BMC firmware. Still don't have a solution the workstation boots but it just takes about 8-10 minutes whilst the motherboard is trying to load the firmware before it gives up and loads the BIOS.
Cheers
Paul

Roland.Pezzei:
did you find any solution. i have currently the same error. after the BMC Update to 888 i got the error that BMC can't be initialized any more. downgrade and resetting the settings didn't help

toomanylogins:
No still stuck with the problem and Gigabyte not very helpful. At one point was going to send board back but didnt hear anything further. I think the 888 update is the cause of the problem. Have you contacted support ?
I have just sent another support request. Can you do same https://esupport.gigabyte.com/#id:838295

Navigation

[0] Message Index

[#] Next page