Hi Everyone,
I am sure this has been asked a million times and I ran through searches everywhere and tried various things, but RGB fusion simply won't detected the 3080 on my new rig. I had the 3080 installed on my old rig and it detected it okay with just fusion installed, but this fresh build simply won't have it.
When I load up fusion it takes an age to load and when it does I am just presented with a blank motherboard picture. I think on two occasions it detect 3 of my 4 DIMMs, but never the graphics card and the DIMMS is pot luck on when it detects them.
Things I've tried:
* Tried latest NVidia drivers.
* Used DDU to remove latest NVidia drivers, uninstalled Engine and Fusion, installed drivers listed on Gigabyte site, reinstalled engine and fusion.
Below tried with recommended drivers left installed:
* Uninstalled all other RGB software - Asus Aura, Lian-Li L Connect, iCue, NZXT Cam, uninstalled engine and fusion and reinstalled both with no other RGB software installed.
* Tried just RGB fusion which I had on my old rig (didn't use engine).
* Used CCleaner to clean registry after every uninstall.
PC:
5900x
Asus Dark Hero x570
Gigabyte 3080 Xtreme
G-Skill Trident Neo 32gb
Short of a fresh Windows install again and ONLY installing engine and fusion I'm at a dead end. No other RGB software has issues like Fusion.
