Official GIGABYTE Forum

GA-Z77X-UD5H - Issues

scious

  • 2
  • 0
GA-Z77X-UD5H - Issues
« on: May 14, 2012, 11:43:51 pm »
Just built a computer with the above keyboard.  There are several issues that people should be aware of.

1.  CPU HS fan would not fit as the memory is too close.  Nocuta 14.  The bottom of the fan hits the memory.
Solution - different HS fan.

2. Video card sits over the SATA connectors.  nVidia GTX 680.

3.  Cant enter BIOS or even boot up with a logitech 510 keyboard connected.
Solution - buy a $6 keyboard to do the above.  Ridiculous situation.

Not to say the mb is not a good option but the above issues are ridiculous on what is meant to be a better than average mb.
« Last Edit: June 28, 2012, 05:12:56 pm by runn3R »

Dark Mantis

  • *
  • 18405
  • 414
  • 10typesofpeopleoneswhoknow binaryandoneswhodont
    • Dark Mantis
Re: GA-Z77X-UD5H - Issues
« Reply #1 on: May 15, 2012, 08:00:48 am »
Just built a computer with the above keyboard.  There are several issues that people should be aware of.


Do you mean motherboard rather than keyboard ?

1.  CPU HS fan would not fit as the memory is too close.  Nocuta 14.  The bottom of the fan hits the memory.
Solution - different HS fan.


It is merely a combination of the huge Noctua cooler and high ram heatsinks. Most people opt for low profile memory sticks in this circumstance. Personally I just modified the heatsink by removing the bottom four fins on that side and now I can use even the big modules like Corsair Vengeance.

2. Video card sits over the SATA connectors.  nVidia GTX 680.


This is not normally a problem as the ports are angled so that the cables exit at right angles to the board.

3.  Cant enter BIOS or even boot up with a logitech 510 keyboard connected.
Solution - buy a $6 keyboard to do the above.  Ridiculous situation.

Not to say the mb is not a good option but the above issues are ridiculous on what is meant to be a better than average mb.

Usually it is because either the keyboard is connected via a port other than the rear mounted USB2.0  ie through a hub or using the front ports etc or the settings in the BIOS are not properly chosen. Make sure that the Legacy USB settings are enabled.
« Last Edit: May 15, 2012, 08:01:36 am by Dark Mantis »
Gigabyte X58A-UD7
i7 920
Dominators 1600 x6 12GB
6970 2GB
HX850
256GB SSD, Sam 1TB, WDB320GB
Blu-Ray
HAF 932

Gigabyte Z68X-UD5-B3
i7 3770K
Vengeance 1600 16GB
6950 2GB
HCP1200W
Revo Drive x2, 1.5TB WDB RAID0
16x DLRW
StrikeX S7
Full water cooling
3 x 27" Iiy