Official GIGABYTE Forum

Questions about GIGABYTE products => Motherboards with Intel processors => Topic started by: Jenson on February 07, 2013, 12:25:54 pm

Title: x58 Usb3 Rev 1
Post by: Jenson on February 07, 2013, 12:25:54 pm

Hi people

I have been using a x58 usb 3 rev 1 for couple of years now with no problems, I decided to get some upgrades, so I purchased a SSD 120gb and some ram etc, however I cannot get windows to write to the ssd, it is showing on the screen when it first boot's up, but not when I go into the bios, I have set it to AHCI, i have tried just having the ssd plugged in, but when windows come to the choice of drive, nothing is shown, anyone else had similar problem with this?

Many thanks

Title: Re: x58 Usb3 Rev 1
Post by: Graceman on February 07, 2013, 03:11:59 pm

Switch it back to IDE I have same board and it does not like to run AHCI it just cycles through boot process over & over again so I use IDE.
I have tried several configurations and now have Bios F8a but it still does not want to use AHCI

Title: Re: x58 Usb3 Rev 1
Post by: Jenson on February 07, 2013, 03:14:30 pm

right ok, ill try that, will I still be able to write to the ssd, it is set to IDE?

Thanks

Title: Re: x58 Usb3 Rev 1
Post by: Graceman on February 07, 2013, 03:31:47 pm

I do not see why not its still a Sata drive type isn't it?
Aalso be aware that this board has faulty Gstat6 Sata drive software from Marvell on ports 6&7 its a well documented issue here in teh forum. sotry another sats connection and disable the Gstat6/7 in Bios.
I currently have F8a Bios running on my Ga X68a Ud3r board.