Official GIGABYTE Forum
Questions about GIGABYTE products => Motherboards with AMD processors => Topic started by: SyntheticD on December 16, 2013, 03:04:33 pm
-
upgraded memory for 1066 gskill ripjaws to 1866 gskill ares. i get memory issue post beeps i have tried reseating the memory im using a fx4170 zambezi. if i reinstall my 1066 it works just fine. kinda lost for ideas
-
figured it out had the memory in the wrong slots
-
no the memory is only reading at 1333 its Gskill Ares 1866 8 gigs is there bios setting i need to adjust to make it work?
-
There are two available ways to set up the memory speed. If manually setting the Memory Clock, you should also manually set the DRAM Timings and DRAM Voltage to the memory manufacturers recommended settings.
DRAM E.O.C.P
Allows you to determine whether to use the preset memory overclocking profile to achieve optimum overclocking performance. (Default: Disabled)
Set Memory Clock
Determines whether to manually set the memory clock. Auto lets BIOS automatically set the memory clock as required. Manual allows the memory clock control item below to be configurable. (Default: Auto)
Memory Clock
This option is configurable only when Set Memory Clock is set to Manual. The adjustable range is dependent on the CPU being installed.
X6.66 is 1333MHz
X9.33 is 1866MHz
-
im using the fx-4170 i went to adjust manually set the voltages to manu specs. then went to it to 9.33 and save and exit. it post beep 1 long and then reset.