Official GIGABYTE Forum

Questions about GIGABYTE products => Motherboards with Intel processors => Topic started by: Dirtnapper on July 28, 2014, 11:45:14 pm

Title: HD's not showing up
Post by: Dirtnapper on July 28, 2014, 11:45:14 pm

I have two WD 250 Caviar hd's I put into the system. However, they do not show up and I do not see them in BIOS as well. They are on the Marvel ports, GSATA3 6/7. Intel ports are full.  The Marvel driver and  storage utility are both installed. I would like to use them for extra storage. Thanks.

Title: Re: HD's not showing up
Post by: absic on July 29, 2014, 06:17:30 pm

Stupid question but, you have enabled the Marvell Controller in BIOS?

Title: Re: HD's not showing up
Post by: Dirtnapper on July 29, 2014, 08:58:48 pm

Checked BIOS and it looks ok.

Title: Re: HD's not showing up
Post by: Dirtnapper on August 02, 2014, 06:25:08 pm

Update: I switched the hd's to the ports 0 and 2 and they now show up. It appears maybe  ports 1 and 3 might have an issue. I also updated BIOS to F9. Any ideas on this?
Thanks.

Title: Re: HD's not showing up
Post by: Dirtnapper on August 08, 2014, 08:02:51 pm

I have a Xship from Gigabyte due in Monday, I hope the replacement board solves this Marvell issue as well as the USB ports.

Title: Re: HD's not showing up
Post by: Dirtnapper on August 13, 2014, 06:47:46 pm

Got the replacement, however, only one port on the Marvell chip works. Tried different hd's and cables from the Intel chip and only port0 works.  ??? I also got the same rev 1 mobo, not a newer revision.