Official GIGABYTE Forum

Questions about GIGABYTE products => Motherboards with Intel processors => Topic started by: leo1954au on April 27, 2015, 09:29:04 am

Title: CASE DOCKING STATION
Post by: leo1954au on April 27, 2015, 09:29:04 am

I have a G1 Sniper Z97 in a Thermaltake Chaser Mk 1 case with a  top HDD docking station and since I've  upgraded my bios from F4 to F6 the docking station no longer works even after  I went into the cmos and made sure the Sata mode setup was set to AHCI.

Is there any other setting that I might have missed that would stop my PC reading a drive in the docking station ?

Title: Re: CASE DOCKING STATION
Post by: dmdilks on April 27, 2015, 12:54:33 pm

What port on the board do you have that plug into. After you update the bios did you clear the cmos and set it to default settings? Or at lease set it to the default settings.

Title: Re: CASE DOCKING STATION
Post by: leo1954au on April 28, 2015, 04:03:07 am

 I have it pugged into sata port 3 and no I never cleared the cmos on the board itself after updating the bois I just reset the board to default values in cmos settings .

When I plug a drive into the docking station I can hear the drive spinning up ok but windows is not detecting it