Official GIGABYTE Forum
Questions about GIGABYTE products => Motherboards with Intel processors => Topic started by: trafford on November 28, 2015, 05:21:25 pm
-
I have a GA-P67-UD4-B3 Mb
Intel 2600K cpu
450GB SSD
256GB SSD
1TB HDD
1TB HDD
Gigabyte Geforce GTX 770 4GB
8Gb DDR3 Corsair Ram ( 1600MHZ ) 9-9-9-24
My problem is that i have purchased Kingston Hyper X Fury 16GB ram Kit
http://www.kingston.com/en/memory/search?DeviceType=7&Mfr=GIG&Line=GA-P67A-UD4-B3&Model=76047
When i install it to slot 2 and slot 4 on the MB the computer just gets stuck in a boot loop , but when i put one stick of the old ram back into slot 2 and the hyper x into slot 3 and 4 the computer boots up, i would like to know why does this happen , any of you guys got any ideas .
Im also running Windows 10 Pro 64bit
-
Greetings,
Only one rev of your board (v1.1). What BIOS version are you running?
Start here
Channel 0: DDR3_1, DDR3_2
Channel 1: DDR3_3, DDR3_4
When enabling Dual Channel mode with two or four memory modules, it is recommended that memory of the same capacity, brand, speed, and chips be used for optimum performance. Mixing is not recommended
Have you tried the new ram is slots 1 and 2 (only) no other RAM installed. what are the results?
You may have to set the memory specs manually. Try a different BIOS (newer)
-
I am running Version F5 bios and i have tried the 2 new modules in slot 2 and 4 as my cooler covers slot 1 , i have cleared the cmos , but now have refitted the older ram now , im at a loss
-
Solved , i just put the frequency down to 1600Mhz and now works fine