Official GIGABYTE Forum
Questions about GIGABYTE products => Motherboards with Intel processors => X99 Motherboards => Topic started by: DTFrontMan on July 15, 2016, 01:49:25 pm
-
I'm currently not getting my new build to boot up. It powers on for a second or two before shutting down then cycles off and on like that. I've switched out my PSU for one that I know works and it's doing the same thing. No VGA currently installed, I had 4 DDR4 sticks installed but removed them while testing based on suggestions online. Currently just trying to power on with CPU and nothing else installed. CPU is a brand new i7-6900K. Should this be working at all?
-
I was able to get it to flash a new version of the BIOs so I'm assuming the motherboard isn't fried. Reading around I've seen people suggest RAM is the issue, mine is 2666MHz.
When I had this error, I had four 8gb Kingston HyperX Fury DDR4-2666 modules installed, I installed one stick of DDR4-2133 into DDR_4_3_1B, from there I was able to use the UEFI to force the settings to use 2400MHz and it worked fine after I reinstalled the DDR4-2666 (running at 2400mhz vice 2666mhz)
So I have a 4GB stick of DDR4 2133MHz on the way to try this.
Can anyone confirm what all I need connected to get into BIOs? I'm trying to keep the number of variables at minimum so if anyone knows what all I actually need it would be helpful.
-
I had to 2 16 gig sticks of vengeance higher mhz , I put 2 4 gig at 2133 n this sorted the power up then off as you describe
-
If..... someone have a problem with PROPERLY gigabyte motherboards start (loops etc) - PLEASE put in !everything! (procesor, memorys, g.card, hard drives - floppys ;) ) as should by and press&hold both buttons 'POWER+RESET' for 5-7 sec!!
I know this is stupid, but it works!! :P
******************
SRY FOR MY ENGLISH