Official GIGABYTE Forum
Questions about GIGABYTE products => Motherboards with Intel processors => Topic started by: Skofab on September 19, 2017, 08:24:12 pm
-
Hi everyone.
Have been playing around with the graphics on my PC (Win 10 32 bit) Gigabyte
For yonks I have used a GT610 with no problems whatsoever. I decided to see how the boards integrated graphics would compare, and ran this (OK) for a couple of days.
I was then given a new (ish) GT710 2Gb card. I was able to install the latest drivers no problem.
At the moment I have a tremendous delay when booting up (takes about a minute). Whilst booting up it beeps once every 20 seconds or so - this happens for three occasions - after this all is well, it boots up and everything is as it should be.
My BIG problem is that with the card fitted - pressing delete does not gain entry into the bios. I suspect that the setting is at other than PEG (hence the delay.)
Have I missed something here, is there a workaround OR have I got a duff card.
Your thoughts and suggestions will be welcomed.
-
Should have mentioned that the Motherboard is a H61M-S2PV board
-
You could try booting with the card that worked, go into bios and set for PEG. Shut down the pc, reinsert the new card and then try to boot. Or remove the card and try to boot with onboard graphics then adjust bios.