Official GIGABYTE Forum
Questions about GIGABYTE products => Motherboards with Intel processors => Topic started by: k3nj23 on May 30, 2010, 10:22:43 am
-
Hello
This is my spec
Gigabyte GA-EP45-UD3P
Gigabyte HD5850
Intel Core2Quad Q9400s @ 2.66Ghz (Default)
Seagate 7200.12 500GB
Patriot 2x2GB 1066Mhz 5-5-5-15 2.1V Memory | Here |
Enlight Black Silver 600W
XSPC Pump + Resevoir, Thermaltake TMG 1 12x1 Radiator
I have upgraded my Bios to latest, but still same problem
It wont boot on 2 stick memory (Slot1 and Slot3), No beep, no post, just restart continously.
I changed Bios to Manual (Other than this, is Auto)
PCI Express Frequency (Mhz) ---------- : [100] <--- Set to 100, never leave this on Auto
Standard Timing Control
CAS Latency Time -------- 5 ---------- : 5
tRCD ------------------- 7 ---------- : 5
tRP --------------------- 7 ---------- : 5
tRAS ------------------- 20 ---------- : 15
MCH/ICH
MCH Core ---------------- 1.100V ------- : 1.200
MCH Reference ----------- 0.760V ------- : [Auto]
MCH/DRAM Ref ------------ 0.900V ------ : [Auto]
ICH I/O ----------------- 1.500V ------- : [Auto]
ICH Core ---------------- 1.100V ------- : [Auto]
DRAM
DRAM Voltage ------------ 1.800V ------- : 2.1V < NORMAL VOLTAGE
DRAM Termination -------- 0.900V ------- : [Auto]
Channel A Reference ----- 0.900V ------- : [Auto]
Channel B Reference ----- 0.900V ------- : [Auto]
But there are a beeps (23 Times and restart) this time.....
-
I would try swapping out your PSU(even though it's a decent one) for something a bit heavier. These boards seem to be a bit power hungry.
-
I would try swapping out your PSU(even though it's a decent one) for something a bit heavier. These boards seem to be a bit power hungry.
Oh please don't be silly, his system won't stress any halfway decent PSU, and besides, we are talking "BOOT" here, not load in 3D mode :)
OP, does each stick boot in isolation in DDR3_1?
-
I would try swapping out your PSU(even though it's a decent one) for something a bit heavier. These boards seem to be a bit power hungry.
Oh please don't be silly, his system won't stress any halfway decent PSU, and besides, we are talking "BOOT" here, not load in 3D mode :)
OP, does each stick boot in isolation in DDR3_1?
I can assure you that I wasn't being silly! I am using a GA-X58A-UD7(the next one to yours) and I couldn't get it to boot with a decent 750w psu. I had to put in a Corsair HX850 to get it stable. Anyway good luck with your new build, I will watch with anticipation.
-
+1^^ I think it is a power issue. He has memory voltage and MCH voltage in the ballpark, he could list his memory strap for us tho.
-
Hello
thanks for reply
Its has been fixed now, i set tRD to 7-8 and my motherboard boot fine on 4GB