Official GIGABYTE Forum
Questions about GIGABYTE products => Motherboards with AMD processors => Topic started by: Rotten on November 07, 2010, 07:05:11 pm
-
I have looked at my user manual and it says my Graphics card is not inserted properly so I took it out it still beeps. Before this I got a few blue screens that consisted of irql_not_less_or_equal and that just said there was a problom and the system need to be restarted
My Specs:
MotherBoard: M68MT-D3
CPU: AMD Athlon II X4 620
Memory: Patriot 2GB PC3-10666 1333MHz
Power Supply: Power Up LT 400w ATx
Graphics Card: GeForce 9400 GT 1GB DDR2
-
I am not familiar with this board but from what I can see it has onboard graphics. I would advise trying to boot from this first with the graphics card removed. Connect your monitor to the onboard port. If you are still having problems try clearing the CMOS memory first by removing the motherboard battery and leaving it for at least ten minutes before replacing and rebooting. If boot is successful load Optimised BIOS defaults and make any changes you want to before saving and quitting.
Have you got 2 x 1 GB memory modules or 1 x 2 GB module?
The manual recommends a 500W minimum PSU also.