Official GIGABYTE Forum

Questions about GIGABYTE products => Motherboards with AMD processors => Topic started by: Blackt3ars on February 04, 2011, 05:20:08 am

Title: Need Help for my Ga-m61pme-s2
Post by: Blackt3ars on February 04, 2011, 05:20:08 am

i`ve accidently play with the M.I.T system ...it suppose to be 1600mhz...but i switch it to 3600mhz and now....when after safe and exit.....nothing appear in my screen and i can`t see anything accept blank screen ( and also i have graphic card attach ) anyway to reset ? the setting ? all i can see is black screen and nothing appear sigh

Title: Re: Need Help for my Ga-m61pme-s2
Post by: bytheway_r on February 04, 2011, 05:32:09 am

Turn off the PSU then click the power button to use up any electricity left. Then either connect ( with a screwdriver, anything made of steel ) the 2 pins labeled as CLR_CMOS or remove the CMOS battery. If you go the pins way then remember to keep them connected for a few seconds to be sure that you cleared CMOS. Both the pins and battery are just under the blue PCI-E slot ( for more info, they should be described in the manual ).

This way you'll have your bios reset to default. Hope this helps!

Title: Re: Need Help for my Ga-m61pme-s2
Post by: Blackt3ars on February 04, 2011, 05:41:20 am

THx Man >.< almost a second there i was so lost haha....i think never wanna touch that thing again....it works and all fine =)....

Title: Re: Need Help for my Ga-m61pme-s2
Post by: Dark Mantis on February 04, 2011, 12:15:50 pm

Just remember to load Optimised BIOS Defaults after clearing the CMOS and also change any settings to boot order etc that you normally use before save and exit.