Official GIGABYTE Forum
Questions about GIGABYTE products => Motherboards with Intel processors => Topic started by: shaneb310 on April 19, 2011, 04:05:33 am
-
hi i just got my second p67a-ud5-b3 board from an rma and im stilll geting the same thing, when i load the win7 cd up and at the bottom of the screen u see it loading all the oem drivers and stuff and when it's done , it says now starting windows start up and after about 4 secs of that it go's to a blue screen.
this is the second board to do this, this only happens when i put the chip set to raid for my ssd or my raptors ether or , and iv tryd leaving it with no hard drives and just have the cd installed and same thing if i turn off riad i just use it reg, the it boots just fine
i have told giga byte about this and they said try diffent sata ports and i did this with 4 sets of diffent drives and same thing with or with out hd connectd at all
cpu i7 2600k stock speed no oc at all
5800 gtx
CORSAIR DOMINATOR 6g kit
1000w psu
i also diconnect the usb keyboard and mouse and turnd off all usb 3 and 2 ports firewire , nic, sound , no help
-
Hi and welcome to the Gigabyte Forum.
The next thing to try is to clear the CMOS. Please follow these instructions exactly.
Remove the power cable from the mains supply and then press the power switch on the case for a few seconds just to drain any residual energy in the PSU capacitors.
Once done remove the motherboard battery for at least one hour before replacing it.
Next plug back into the mains supply and boot.
You will now need to enter the BIOS by pressing DEL and load Opimised BIOS Defaults.
Make any other changes to the BIOS settings to suit your self like disabling the floppy drive, disabling the full screen logo and making the HDD the primary boot device and then press F10 to save and exit.
-
i did what u said and no go, still blue screen :'(
-
OK. So what drives have you got connected ?
and in what ports are they installed ?
-
well i finaly got win7 installd and now i cant get it to run right ..after about 30 of gaming it freezes every times , i do have it oc at 4g clock and disabled the turbo on the chip, have the vcore at 1.37 and still freezes kinda dont like this new p chip set , iv had nothing but bad news for the last 3 mounths board after board , my 920 at 3.8 still runing like a champ ater 2 years dont know what to say about this
-
You still haven't answered my previous question regarding which ports you are using ?
I would try and run it at stock speeds before you try and overclock it though. How do you know it is stable if you haven't tried it at stock ?
-
um sorry for not geting back at u about the ports , it wasnt any of the ports being bad it was my cd drive was bad , i took my pioneer out of my 920 system and work great for the install, i do have it right now as i type this at stock clocks every thing and vcore is auto with most of the settings now , if for some reson it is stable ill be kinda of upset, pay 4k for a system that is slow than my 920 , not to cool, if u have any points on ocing 2600k im all open for it, i read about vcore seting and see somthing about vpll but cant find what to set the pll to vs the vcore
-
Yes but the point is you should always build the system and then run it at stock settings for a while to iron out any little niggles there might be first before you start trying to raise the speed.