Official GIGABYTE Forum
Questions about GIGABYTE products => Motherboards with AMD processors => Topic started by: ritual93 on January 02, 2012, 06:42:59 pm
-
Hi, i have just recently purchased this board, and the graphics card is not getting detected at all.
Latest Bios, and have more then enough power
And also another question, i bought a 2x2gb 1066mhz kit, and when i have both modules in the board, the pc keeps freezing or restarting itself, but it works 100% perfect with just 1 of the modules in, why would that be? as they both work fine alone?
--------
Corsair 750W PSU
2gb Ram 1066
AMD 6000 +
Thank you.
-
Hi ritual93 and welcome to the forum.
Have you tried a full CMOS clearance and what brand and specification are your RAM modules?
CMOS clearance:
Remove the power cable from the mains supply and then press the power switch on the case for a few seconds just to drain any residual energy in the PSU capacitors.
Once done remove the motherboard battery for at least one hour before replacing it.
Next plug back into the mains supply and boot.
You will now need to enter the BIOS by pressing DEL and load Optimised BIOS Defaults.
Make any other changes to the BIOS settings to suit your self like disabling the floppy drive, disabling the full screen logo and making the HDD the primary boot device and then press F10 to save and exit.
Take care with electricity...safety first.
teknology9
-
So do you know anything about the graphics card issue?
And the RAM are Kingston HyperX ddr2 1066
-
Hi,
Are there any beeps when you power up? Have you tried another graphics card that works just to narrow things down?
Are you sure that everything is seated properly and connected as they should be?
Teknology9