Official GIGABYTE Forum
Questions about GIGABYTE products => Notebooks and netbooks => Topic started by: Blaxland.john on September 03, 2015, 01:23:59 am
-
I have attempted to upgrade from windows 7 to windows 10 on three occasions.
On the third attempt all looked good. I upgraded the Video driver using driver update -
A restart was also requested by windows 10.
After the restart :
Bios screen and the friendly sound indicating windows is logging in.
Then no Screen.... the Hard disk is accessed all the time with rest times of a few seconds.
I managed to activate Network logging in when I first accessed Windows 10. I can view files using another PC
Any thoughts.?
I noticed the Memory is using 2.7 out of 3.9 GB and I am looking at upgrading to at least 6 GB Memory
-
I have read the Thread
Format C:\Drive then reinstall.
The Q2532 eventually say 6 -24 hours later goes to sleep . Wake it up and log in all is oK .
My comment is this reloading from recovery partition or some where else.
My conclusion in my case is to get a new Hard drive format C: & D: drive and load windows 10.
Where does all the Fn Key info come from?
SAY WIFI on /OFF as an example.
Surely there are others out there that have upgraded to windows 10 .
How did you do it ?