Official GIGABYTE Forum

Gigabyte 970A-D3P Linux NIC/USB issues

Gigabyte 970A-D3P Linux NIC/USB issues
« on: April 09, 2015, 02:17:46 pm »
I've tried Debian, Mint, Arch and Bridge to no success. Essentially my issue is, I can't get a network connection. I was able to get Arch to recognize back panel USB ports, however with debian based distros, this is not the case. Does anyone have any experience getting this particular board?

Build: FX-6300, 16GB 1600MHz ADATA, R9 280, GIGABYTE 970A-D3P running F6F. I'd prefer to get this working with either Debian or Mint, but I'll take any distro.

Vezina

  • 871
  • 10
  • If it s not broken, fix it until it is !
Re: Gigabyte 970A-D3P Linux NIC/USB issues
« Reply #1 on: May 03, 2015, 07:15:38 pm »
Try Open Suse and Ubuntu, never found better linux distroes than this ones.The other ones are to experimental
Over & Out !

AMD FX (APU-s included) users should install - KB2645594 & KB2646060 under Windows 7

1.ASUS Sabertooth 990FX 2.0 + FX 6300 + H60
2.MSI A88X-G41 PC Mate + A8 5600K + Hyper TX 2
3.Gigabyte F2A75-D3H + A4 5300
4.ASUS AM1M-A + Athlon 5150

Re: Gigabyte 970A-D3P Linux NIC/USB issues
« Reply #2 on: May 15, 2015, 06:29:48 pm »
Could be iommu issues like we see on 970A-UD3P?

http://forum.giga-byte.co.uk/index.php?topic=14812.0

Re: Gigabyte 970A-D3P Linux NIC/USB issues
« Reply #3 on: September 12, 2017, 02:53:21 am »
I've tried Debian, Mint, Arch and Bridge to no success. Essentially my issue is, I can't get a network connection. I was able to get Arch to recognize back panel USB ports, however with debian based distros, this is not the case. Does anyone have any experience getting this particular board?

Build: FX-6300, 16GB 1600MHz ADATA, R9 280, GIGABYTE 970A-D3P running F6F. I'd prefer to get this working with either Debian or Mint, but I'll take any distro.

in boot grub use this parameter: iommu=soft

with that all the usb ports worked normally with total speed and without problems including usb 3.0

if it's with an nvidia video card

in boot grub use this parameter: iommu=soft nomodeset

 

anything