Official GIGABYTE Forum

Slight bow okay?

Slight bow okay?
« on: March 11, 2017, 09:42:25 am »
Will make this as short as possible. This is my sixth build, first with Intel in YEARS (couldn't be happier btw). 6700k so I had to order an aftermarket cooler, went with the 212 evo. Anyways noticed in my old case that my Z170 UD3 Ultra bowed in the middle, turned out my old case had seen better days and the mobo tray was warped. So bad that you could tell by looking in the back of the I/O shield.

So got a new case, everything seems perfect. Can still feel a slight bow at the top of the mobo, and by that I mean if I run my finger across the top I can feel where it tightens up then opens up again. I'd imagine this shouldn't effect anything in the long run, right?

A disclaimer here, no I did not tighten the crap out of the bracket and cooler, I have also tried re-installing it. No interest in an AIO cooler, idling at 21c and when gaming at 50% load I see about 38 to 40c,  yes I live in an igloo.

shadowsports

  • 2243
  • 67
  • Xbox One, Drives STI, Use QVL RAM For Best Results
    • Gigabyte US
Re: Slight bow okay?
« Reply #1 on: March 11, 2017, 03:41:35 pm »
Although not ideal, 1-2mm of bowing is probably not going to cause any issues in the long run.  You'd have to be the judge, but this variance is small.  If cards, your cooler and memory seats properly, the board should function without a problem.  Good idea to change out the case, sounds like it was time anyway.   
Z390 AORUS PRO (F10) \850w, 9900K, 32GB GSkill TriZ RGB - 16-18-18-38, RTX 3080Ti FTW3 Ultra, 960 Pro_m.2, W11
Z370-HD3P (F5) \750w, 8350K, 8GB LPX 3200 - 16-18-18-38, GTX 970 FTW SC, Intel SSD, 2TB RAID1, W11
Z97X-UD5H \850w, 4790K, 32GB Vengeance, RTX 2080 FTW

Re: Slight bow okay?
« Reply #2 on: March 12, 2017, 05:24:28 am »
Although not ideal, 1-2mm of bowing is probably not going to cause any issues in the long run.  You'd have to be the judge, but this variance is small.  If cards, your cooler and memory seats properly, the board should function without a problem.  Good idea to change out the case, sounds like it was time anyway.   

Removed the board last night just to check it out. Seems that its just naturally bowed that way. Even installed the HSF after I installed the board in the case. Setting the board on a flat surface, you can see where it actually slightly angles up towards the I/O where the PS/2 port is.