Official GIGABYTE Forum

GA-H110M S2H won't boot

biuro74

  • 13
  • 1
GA-H110M S2H won't boot
« on: April 17, 2018, 03:04:55 pm »
Hi,

I've assembled PC and suffer issues with beep codes, which I'm not quite sure how to interpret them.

Speaker buzzes 4 long beeps and 1 short, which is interrupted by reset.
Motherboard is powered up - all fans do work, there's some ilumination. BIOS was in unknown revision, so I've reprogrammed it with MiniPro 866CS to F24 revision that supports KabyLakes (succesful reprog, 8192KB file that doesn't contain additional config data, like Asus CAP files).

CPU is Pentium G4600.
RAM I've checked with single, dual config, each slot. Still the same.

All components are purchased from Ebay, so I can't be sure they are 100% supposed to work. Sometimes sh*t happens - like yesterday when courier deliveres completely smashed CPU cooler :/ Thing is I might presume some component's fault, but not sure which one it is.

I've found info:
https://www.gigabyte.com/Support/Faq/816
that says "continuous long beeps" (which I can treat as main beeps, because last beep is like interrupted by reset) means wrong memory. However, when I remove both memory sticks, I get the same beeps.
If CPU was faulty - so I probably got 6 short beeps.

CPU socket was without bent pins.
Power supply is brand new, no graphic cards are attached (just VGA and DVI monitors).

Any thoughts, please ?
« Last Edit: April 17, 2018, 03:08:08 pm by biuro74 »

biuro74

  • 13
  • 1
Re: GA-H110M S2H won't boot
« Reply #1 on: April 17, 2018, 09:34:36 pm »
I've found 3 bent pins. I've repaired two of them - third broke as its end was tilted to the other way, so during bending back this small end torn off. So I took thinnest tip to my soldering station, mixed some low-temp tin to normal one, lowered temp to make whole tin "stretchy" and added missing part. Not sure it that's enough to make a contact with appropriate CPU pad, but motherboard still beeps and restarts. Maybe I'll add some solder to appropriate pad to CPU to make sure there's no gap between them, or it's rather not relevant - looking at these beeps ?

shadowsports

  • 2243
  • 67
  • Xbox One, Drives STI, Use QVL RAM For Best Results
    • Gigabyte US
Re: GA-H110M S2H won't boot
« Reply #2 on: April 18, 2018, 03:02:14 pm »
eBay purchase, bent, broken pin(s).  Did you take the BIOS chip off the board to re-program?  There could be hidden damage you may never know of.  I'd replace the board and call it a day.  Congrats for being a member since 2009.   8)
« Last Edit: April 18, 2018, 03:05:40 pm by shadowsports »
Z390 AORUS PRO (F10) \850w, 9900K, 32GB GSkill TriZ RGB - 16-18-18-38, RTX 3080Ti FTW3 Ultra, 960 Pro_m.2, W11
Z370-HD3P (F5) \750w, 8350K, 8GB LPX 3200 - 16-18-18-38, GTX 970 FTW SC, Intel SSD, 2TB RAID1, W11
Z97X-UD5H \850w, 4790K, 32GB Vengeance, RTX 2080 FTW