Official GIGABYTE Forum

Blank screen after enabling secure boot, any way to fix it?

Aralon

  • 2
  • 0
Blank screen after enabling secure boot, any way to fix it?
« on: September 06, 2019, 02:04:19 pm »
So i was trying to reinstall windows 10 in uefi mode(currently in legacy) so someone suggested to enable secure boot before putting the flash drive and i did so, to enabke secure boot i used the default gigabyte platform keys and then save and exit, as soon as i rebooted my screen was blank and the led codes on my mb were showing A9(bios setup is started),so i did a cmos reset using jumper and now it is stuck at code d6(no console output devices found) i have a z390 aorus ultra motherboard and i have no idea what to do now, no other forums have been helpful.I have high hopes that someone from here might just help me out.
« Last Edit: September 06, 2019, 02:04:55 pm by Aralon »

Aralon

  • 2
  • 0
Re: Blank screen after enabling secure boot, any way to fix it?
« Reply #1 on: September 08, 2019, 08:06:40 am »
bump!  :-\
« Last Edit: September 08, 2019, 08:07:15 am by Aralon »

shadowsports

  • 1761
  • 52
  • Xbox One, Drives STI, Use QVL RAM For Best Results
    • Gigabyte US
Re: Blank screen after enabling secure boot, any way to fix it?
« Reply #2 on: September 08, 2019, 06:46:23 pm »
Greetings,
So the community has a complete picture of your environment, please provide you full system specs, including BIOS rev.

Are you able to enter BIOS?  If so, please load Set Up Defaults and save. 

-Can't do that?  Please remove your MB Battery for 3-5 Min

What display device are you outputting to?  Are you using adapters of any kind?

 
Z390 AORUS PRO (F10) \850w, 9900K, 32GB GSkill TriZ RGB - 16-18-18-38, RTX 2080 FTW3 Ultra, 960 Pro_m.2, W10 1903
Z370-HD3P (F5) \750w, 8350K, 8GB LPX 3200 - 16-18-18-38, GTX 970 FTW SC, Intel SSD, 2TB RAID1, W10 1903
Z97X-UD5H \850w, 4790K, 16GB Vengeance, GTX 970 FTW SC, RAID0