Official GIGABYTE Forum

Ordered GA-EP45-UD3P mother board for whs

Ordered GA-EP45-UD3P mother board for whs
« on: August 09, 2009, 02:37:55 pm »
Hello to all I havev ordered GA-EP45-UD3P motherboard for my DIY WHS. I would  know from anyone if I can expect any problems from this board
in my current project, also I am going to use the Q9550 Processor.

Reagards,

Don

day004

  • 1
  • 0
Re: Ordered GA-EP45-UD3P mother board for whs
« Reply #1 on: August 23, 2009, 10:06:27 pm »
Not so far. Only real problem I've had was a code 18.... The source of the problem was found 18 inches in front of the monitor.
If you  use a raid setup and flash the bios, the defaults are reinstated, that is no raid. I you try to boot  ,the process breaks the logical raid array. And you're fackered. I fixed it by booting off the Ultimate BootCD and running the raid repair process. Then resetting the BIOS to raid5 and away we went.