Hello Jakk89,
Welcome in the forum,
I have a suggestion for you about your situation.
Make a clear CMOS.
My favorite method is:
disconnect the power cord,
purge the power button in front case,
remove batterie,
Change a positon of the jumper on the motherboard for clear cmos. (Check your manual if necessary).
Make a contact with a paper clip between the batterie connectors fiew 5 sec,
Rechange a normal position of the jumper on the mobo.
Place a batterie
Plug de power cord
Reboot.
If you have a similar method, use it at our convenience.Reboot,
Go to Bios, choose Load Fail Safe Default.
MODERATOR EDIT: Not failsafe default use Optimised BIOS DefaultsF10 to save
Reboot.
Check a Result.
Now make this instructions:
If you are sure about your two sticks of Ram. Just try put Ram in the slot farthest from the cpu. In Dual channel mode.
Because is the best for the ram and cpu (and for your heatsink).
Otherwise....
Just try one by one. In each slot (Bank Ram). And Reboot.
This is very basic like action. But you have a possibility for verify each slot.
Come here again for give news.
Gloup_Gloup.