Kingston ram problems

[Ben]

Noise not that bad, also I moved one of my fans, it used to sit in front of the HDD's now I have it at the back & it seems to be pushing better air.
Temps so far for the CPU =33, 31, 29, 37c respectfully.
HDD's 29, 28.
GPU =28.
This is all normal running.
I notice it seems to pass okay running Prime at 'small FFT'  but when on Blend it freezes after half an hour.
Any ideas?
Also noticed when I run prime, besides the temps going up my wattage goes up also is this okay?
Ben.
PPS.
Almost forgot, Thanks DM for the voltage settings for my ram.
RE; Fan controllers, looking at the 'Aerocool Strike-X Front Touch Panel'  & the  'AeroCool Touch2000 Front Touch Panel'.

[Aussie Allan]

  A system is stable if it does not fail with what YOU do with it.....if you thrash it with a 3 screen flight SIM ..... you might only be able to run at 3.7.

  If the worst you do is a bit of photo-editing....you might be rock solid stable at 4.1 .....it all comes down to your personal usage and what programs you use as to stability ...... best test is to just run it for a week or two and see how it goes under the present config.....if you get the occasional problem....just back it off a tad.....CPU or memory

  I notice it seems to pass okay running Prime at 'small FFT'  but when on Blend it freezes after half an hour.
Any ideas?
                        Probably the tight timmings......again try just using it for a while

   Also noticed when I run prime, besides the temps going up my wattage goes up also is this okay?

  More volts ... more heat.....it's all relative and normal.....with your temps.....you have nothing to worry about!

  Aussie Allan

[Dark Mantis]

PPS.
Almost forgot, Thanks DM for the voltage settings for my ram.
RE; Fan controllers, looking at the 'Aerocool Strike-X Front Touch Panel'  & the  'AeroCool Touch2000 Front Touch Panel'.

No problem only to glad to help.

I agree with Allan there about the stability. It is really how you decide to class stable. Each of us probably has our own ideas.

[Ben]

Thanks for that just didn't want to nuke my system.
Will see how things go for a while.
Ben.

[Ben]

Just a short note to say that all is okay with my system, been running like a Dingo on heat.
Just thought I would add this in, when I was replacing my stock cooler with the "Noctua" one I didn't like the idea of having to rip out my mobo every time I had to replace or fix my cooler, so when I removed the mobo I cut a hole in the back panel so now I can bolt & unbolt to my hearts content, also cut out a square hole on my back side cover & glued a blue acrylic panel there, why? because I felt like it.
Ben.
Again thanks to you guys for all your help.
So until I have another problem for you to solve have a G"Day.

[Dark Mantis]

Glad to hear everything is working out alright Ben and I did the very same thing on my last case as there wasn't a big enough hole in the motherboard tray. A bit of customising later and everything was much easier.