Official GIGABYTE Forum

Z87x UD3H, no signal for monitor, no LED code, it doesn't boot.

b618

  • 1
  • 0
Z87x UD3H, no signal for monitor, no LED code, it doesn't boot.
« on: October 13, 2015, 04:31:20 pm »
I had this motherboard for over a year without issues, a couple of weeks ago after a power off, the computer would power on but no display signal. After resetting cmos, it started no problems. Then the problem happened every time I powered off the computer. I updated to Bios version F9, but after the last power off it now doesn't initialise boot. No signal from the graphic card or the onboard graphics after removing graphic card. I have switched memory around slots, same problem. Removing battery and leaving a jumper on cmos reset switch doesn't solve it. Disconnecting drives, same problem.

shadowsports

  • 2259
  • 67
  • Xbox One, Drives STI, Use QVL RAM For Best Results
    • Gigabyte US
Re: Z87x UD3H, no signal for monitor, no LED code, it doesn't boot.
« Reply #1 on: October 13, 2015, 09:50:53 pm »
Greetings,
This sounds like it could be a BIOS issue.  Please review section 1-8 page 22 of your manual.  Have you made any changes to the BIOS switches (Dual BIOS).  If not, try disabling BIOS 1, enable BIOS 2, and attempt to boot.  If this works, you may want to sync the two BIOS chips.  Its either ALT+F10 or ALT+F12 depending on the BIOS (award, AMI).

« Last Edit: October 13, 2015, 09:52:02 pm by shadowsports »
Z390 AORUS PRO (F10) \850w, 9900K, 32GB GSkill TriZ RGB - 16-18-18-38, RTX 3080Ti FTW3 Ultra, 960 Pro_m.2, W11
Z370-HD3P (F5) \750w, 8350K, 8GB LPX 3200 - 16-18-18-38, GTX 970 FTW SC, Intel SSD, 2TB RAID1, W11
Z97X-UD5H \850w, 4790K, 32GB Vengeance, RTX 2080 FTW