Official GIGABYTE Forum

delay before starting up GA-970A-UD3P

delay before starting up GA-970A-UD3P
« on: July 25, 2019, 04:02:42 pm »
after a nightmare getting this board to recognise the drive and windows 7 installation , I was dismayed to find that the PC would take around one and a half minutes to get on the desktop, in and out of the bios dozens of times , trying to think logically and ending up doubting my sanity ,the long delay turned out to be a lexar pro usb3 card reader , that was allways plugged in my older (gigabyte) system without problems. however with the offending card reader removed I get boot times around 25 sec to a fully loaded desktop . but now I have another all be it minor oddity, when I press the start (on) button on the front of the PC , nothing happens for a full four seconds ,then it starts as normal ,now this is not the end of the world and I can live with it ,  but it just seems odd , I have used this case on a couple of my previous PC's and its allways started pretty instantly , with the fans etc bursting into life as soon as I press it .  any one know what is happening , bios are up to date.

shadowsports

  • 2259
  • 67
  • Xbox One, Drives STI, Use QVL RAM For Best Results
    • Gigabyte US
Re: delay before starting up GA-970A-UD3P
« Reply #1 on: July 26, 2019, 03:21:18 pm »
Greetings,
Good work solving the card reader issue.

The "power on" issue should be easy to diagnose.  Disconnect the POWER_SW connector from the MB header.  Now carefully jump the two pins using a flathead screw driver.  If the system starts right up, its your switch. 
Z390 AORUS PRO (F10) \850w, 9900K, 32GB GSkill TriZ RGB - 16-18-18-38, RTX 3080Ti FTW3 Ultra, 960 Pro_m.2, W11
Z370-HD3P (F5) \750w, 8350K, 8GB LPX 3200 - 16-18-18-38, GTX 970 FTW SC, Intel SSD, 2TB RAID1, W11
Z97X-UD5H \850w, 4790K, 32GB Vengeance, RTX 2080 FTW