Official GIGABYTE Forum

P55-UD3 Question and comments

P55-UD3 Question and comments
« on: January 11, 2011, 03:54:18 am »
G'Day  Folks,

I have just built a PC with the following specs.

P55-UD3 BIOS F11
I5-760
HD 5450 Graphics
2x2GB Corsair xms3 RAM @1333
2 x 500 GB WD Caviar Green SATA drives
Win7 Home Premium 32bit

My question is...

I have configured the drives in Raid 1 config on the Intel ICH10 controller.
However, I did not enable the XHD option in the Integrated Peripherals Bios
as it was not clear to me that I should do so.
It appeared to me that it was only used for Raid0 configuartions.
Was I correct in not enabling this option?
If it does need to be enabled (for better performance?) can it be done now that the system is running?

On another note, I have noticed several posts relating to failures of these Corsair Memory modules.
I also experienced a DOA condition on one of my sticks.
The failure was such that on Power on, the PC would show the initial screen, beep (several combinations)
and restart again. This would just keep repeating.
Thus it was not possible to run the Memory test program.
The only option to troubleshoot was to remove components.
Thus, it would seem that these Corsair memory modules cannot be recommended.

A second note is that my configuration also exhibited the intermittent Beep issue associated with the i5 CPU - Gigabyte MB combination mentioned many times on the web.
Yes, I had Enabled the CPU Temperature warning in the BIOS - and the cure was to Disable it.
It is important that any builder adds the Buzzer to be aware of such issues, and I believe that Gigabyte should include them in any Mobo that does not have an internal one.

Otherwise, all is running well.

Thanks to the Moderators for a great forum.

Dark Mantis

  • *
  • 18405
  • 414
  • 10typesofpeopleoneswhoknow binaryandoneswhodont
    • Dark Mantis
Re: P55-UD3 Question and comments
« Reply #1 on: January 11, 2011, 01:35:58 pm »
Hi and welcome to the Gigabyte Forum. I am glad that you find it useful.

Firstly no problem in not enabling the XHD. It is just useful in some situations like where you want to add drives to a RAID array, etc.

As far as the Corsair memory goes it is some of the better quality RAM that is available for these boards although you have to make sure that you purchase the correct modules for your motherboard model. DDR3 has much more of a compatibility issue than DDR2 had.

I would agree with you 100% that every motherboard should come packaged with a buzzer. For the few pence it would cost it would make a huge difference and save a lot of wasted time in lots of cases.
Gigabyte X58A-UD7
i7 920
Dominators 1600 x6 12GB
6970 2GB
HX850
256GB SSD, Sam 1TB, WDB320GB
Blu-Ray
HAF 932

Gigabyte Z68X-UD5-B3
i7 3770K
Vengeance 1600 16GB
6950 2GB
HCP1200W
Revo Drive x2, 1.5TB WDB RAID0
16x DLRW
StrikeX S7
Full water cooling
3 x 27" Iiy