Official GIGABYTE Forum

How to change primary PCI-E card on MA785G-UD3H

How to change primary PCI-E card on MA785G-UD3H
« on: June 17, 2011, 12:12:12 am »

Hey everyone,

I'm trying to create a crossfire setup on my gigabyte mobo, which is xfire enabled, but the second PCI-E slot is only 4x.

Well, I installed the cards and the drivers, but AMD Vision Engine Control Center shows the 4x card as the primary. I looked through BIOS but found no way to change the primary card. Can anyone PLEASE help?

Dark Mantis

  • *
  • 18405
  • 414
  • 10typesofpeopleoneswhoknow binaryandoneswhodont
    • Dark Mantis
Re: How to change primary PCI-E card on MA785G-UD3H
« Reply #1 on: June 17, 2011, 08:34:04 am »
Hi and welcome to the Gigabyte Forum.

If you only have two slots and one is only 4x then the crossfire is not going to work to it's full performance. Graphics cards need an 8x slot or more to work properly.

I don't think there is any way to change the slot heirarchy but the 16x is normally at the top anyway.
Gigabyte X58A-UD7
i7 920
Dominators 1600 x6 12GB
6970 2GB
HX850
256GB SSD, Sam 1TB, WDB320GB
Blu-Ray
HAF 932

Gigabyte Z68X-UD5-B3
i7 3770K
Vengeance 1600 16GB
6950 2GB
HCP1200W
Revo Drive x2, 1.5TB WDB RAID0
16x DLRW
StrikeX S7
Full water cooling
3 x 27" Iiy

Tiger

  • 276
  • 13
Re: How to change primary PCI-E card on MA785G-UD3H
« Reply #2 on: June 19, 2011, 04:41:34 am »
The specifications for the MA785G-UD3H say it supports ATI Hybrid CrossFireX.

The specifications for the GA-890GPA-UD3H say it supports ATI Hybrid CrossFireX and ATI CrossFireX.

Your board is not a ATI CrossFireX model. ATI Hybrid CrossfireX uses the integrated graphics and a single Hybrid CrossfireX compatible card.
1) GA-Z97X-Gaming 7, G3258,
2) GA-990FXA-UD3 Rev. 1.1, FX-8350
3) GA-AM1M-S2P, Sempron 3850 Kabini