DDR3 Timing Items
Manual allows all DDR3 Timing items below to be configurable.
Options are: Auto (default), Manual.
CAS# latency
Options are: Auto (default), 4T~12T.
RAS to CAS R/W Delay
Options are: Auto (default), 5T~12T
Row Precharge Time
Options are: Auto (default), 5T~12T.
Minimum RAS Active Time
Options are: Auto (default), 15T~30T.
Memory timings (or RAM timings) refer collectively to a set of four numerical parameters called CL, tRCD, tRP, and tRAS, commonly represented as a series of four numbers separated with dashes, in that respective order (e.g. 5-5-5-15).
Set Memory Clock
This option is configurable only when Set Memory Clock is set to Manual.
X4.00 Sets Memory Clock to X4.00.
X5.33 Sets Memory Clock to X5.33. 1066 speed
X6.66 Sets Memory Clock to X6.66. 1333 speed
X8.00 Sets Memory Clock to X8.00. 1600 speed
DRAM Voltage Control should also be manually set. Unganged mode should also be used.
Current count of unstable sectors (waiting for remapping). The raw value of this attribute indicates the total number of sectors waiting for remapping. Later, when some of these sectors are read successfully, the value is decreased. If errors still occur when reading some sector, the hard drive will try to restore the data, transfer it to the reserved disk area (spare area) and mark this sector as remapped. If this attribute value remains at zero, it indicates that the quality of the corresponding surface area is low.
You may want to run CHKDSK by right clicking the drive, click Properties.
Click the Tools tab, and then, under Error-checking, click Check Now
