Official GIGABYTE Forum

Dynamic Energy Saver and Phase LEDs

timtom33

  • 26
  • 0
Dynamic Energy Saver and Phase LEDs
« on: October 14, 2011, 09:45:14 am »
Hi,

How do i get these phase LEDs on the mobo to work? I understand i have to install "Dynamic Energy Saver" but i tried that and it didn't work. Kept saying to enable CE1 EST in the BIOS, which i had already done.

If i go to the downloads section for my board (see sig) Dynamic Energy Saver isn't listed under 'utilities' so i am not sure if i am using the right one...

Tom

Dark Mantis

  • *
  • 18405
  • 414
  • 10typesofpeopleoneswhoknow binaryandoneswhodont
    • Dark Mantis
Re: Dynamic Energy Saver and Phase LEDs
« Reply #1 on: October 14, 2011, 11:33:29 am »
Hi and welcome.

You will need to make sure that you have the newest BIOS version installed before installling the Dynamic Energy Saver utility.
« Last Edit: October 14, 2011, 11:34:29 am by Dark Mantis »
Gigabyte X58A-UD7
i7 920
Dominators 1600 x6 12GB
6970 2GB
HX850
256GB SSD, Sam 1TB, WDB320GB
Blu-Ray
HAF 932

Gigabyte Z68X-UD5-B3
i7 3770K
Vengeance 1600 16GB
6950 2GB
HCP1200W
Revo Drive x2, 1.5TB WDB RAID0
16x DLRW
StrikeX S7
Full water cooling
3 x 27" Iiy

agros

  • 248
  • -10
Re: Dynamic Energy Saver and Phase LEDs
« Reply #2 on: December 13, 2011, 06:53:31 am »
I read that Tune Up Utilities 2012 has an option for maximum, moderate or manaul configure energy saver.
My question is, why someone would choose something different than the maximum energy saver?

Win 7 has also option for minimal energy, I guess this will happen only when system is idle. So, why someone would choose the maximum option?
Gigabyte GA-970A-UD3
PhenomII x4 960T+Scythe Ninja 3 fanless
G.Skill Ripjaws 2x4GB 1600MHz
Sapphire 7750 Ultimate fanless
Intel 330 120GB SSD
Corsair CX 430W Modular
CoolerMaster Silencio 650
Win7 Ultimate 64 SP1