GA-EP45-DS3L - EPP memory do I need to set the voltage?

[Quitch]

My motherboard is currently set to detect the SPD of my memory and appears to be correctly setting it to 5-5-5-15 (assuming the blue numbers next to auto are correct). However, I see the memory voltage is showing next to auto as 1.8, but the EPP requires 2.1. Do I need to set this manually or should this also be detected and set by the board?

[absic]

Hi there,

usually you need to set higher RAM Voltages manually. When you unlock the voltage control in BIOS you will notice a flashing red warning message about over volting but don't worry, this is normal and as long as you set the correct voltage for your modules everything should be fine.