X58A-UD3R and keyboard/mouse in rear USB port

[TrondS]

Why does not BIOS recognize my USB keyboard/mouse when plugged into the rear USB ports? It seems like I have to plug it into the front USB ports located on my cabinet. Is there any BIOS settings that must be altered for BIOS to recognize them?

[Dark Mantis]

Hi

Normally if anything it works the other way around and they are not seen on the front ports. The only thing I can think of would be if the sender was shielded more on the rear and so wasn't getting the signal properly.

What mouse and keyboard is it you have ?

[Gloup_Gloup]

Hi TrondS,

Check parameters in Integrated Peripherals section in Bios:

USB Controllers
Enables or disables the integrated USB controller. (Default: Enabled)
Disabled will turn off all of the USB functionalities below. USB Legacy Function
Allows USB keyboard to be used in MS-DOS. (Default: Enabled) USB Storage Function
Determines whether to detect USB storage devices, including USB flash drives and USB hard drives during the POST. (Default: Enabled)

Choose Enabled.

Edit01 : If you use a Wireless keyboard or mouse , check a batterie force. Maybe is not powerfull.

Gloup_Gloup

[Tinker]

The standard Bios on X58A is USB keyboard enabled, Mouse disabled, so that needs resetting. The USB 3 affected my USB 2
Keyboard / Mouse so disabled it. Found when you plugged in another USB device lost Mouse function from transmitter until
removed & plugged in again.


Regards tinker.

[Gloup_Gloup]

Hi Tronds,

if you do not use a USB3 peripheral
Disable USB3 in BIOS. And after remove the driver pack.

Gloup_Gloup