Questions about GIGABYTE products > Motherboards with Intel processors

Blank screen after enabling secure boot, any way to fix it?

(1/4) > >>

Aralon:
So i was trying to reinstall windows 10 in uefi mode(currently in legacy) so someone suggested to enable secure boot before putting the flash drive and i did so, to enabke secure boot i used the default gigabyte platform keys and then save and exit, as soon as i rebooted my screen was blank and the led codes on my mb were showing A9(bios setup is started),so i did a cmos reset using jumper and now it is stuck at code d6(no console output devices found) i have a z390 aorus ultra motherboard and i have no idea what to do now, no other forums have been helpful.I have high hopes that someone from here might just help me out.

Aralon:
bump!  :-\

shadowsports:
Greetings,
So the community has a complete picture of your environment, please provide you full system specs, including BIOS rev.

Are you able to enter BIOS?  If so, please load Set Up Defaults and save. 

-Can't do that?  Please remove your MB Battery for 3-5 Min

What display device are you outputting to?  Are you using adapters of any kind?

 

chris_yooo:
Hey guys,

i got exact the same problem.

Here are my specs and explain what steps i already done.

Gigabyte Z390 Aourus Elite (bios ver. F10h from 2021.01.19)
Intel i7 9700k
2x 8GB HyperX 2133 Mhz
Samsung NVMe SSD 970 Evo 1TB at M2a port
Samsung SSD 850 Evo 250GB at SATA port

I tried to install Windows 10 Pro x64 from USB Stick (generated with the Windows Creation Tool & later with rufus in MBR Mode and NTFS Mode)..

I tried in various solutions and methods that ive been reed and learned in years of using PC's.. ->
cleared the NVMe
activated UEFI boot (with SATA Mode at AHCI and and in another installation on Intel RST..)
boot from stick
select the NVMe SSD, the first copy and extracting from installation progress.. we all now it ->
reboot
dont work... (pushed me into the Bios)
in bios activate the secure boot option
dont work...
installed the factory keys before the Installation
dont work...
installed the factory keys after the installation
dont work...
tryed without activating secure boot in another installation
dont work...
tryed with the option on "other OS" and the "Linux OS" in Bios/Boot options, and after the first restart pull that back to "Windows 8/10" option..
with clearing of Keys and hold Keys and pulled back to Factory Keys.......
I tried the second NVMe slot M2b
nada...

I got every time when i press f12 an empty boot option, that option push me into the bios ?!

(i cleaned the NVMe complete with disk part -> clean..., i have done all various creations from windows usb stick installation, i tried all various settings in Bios, i tried many solutions ive been read in the www... so)

Btw the installation on my 250GB SSD at SATA Port work without any problems :S

Here some screenshots:

chris_yooo:
more pictures 1

Navigation

[0] Message Index

[#] Next page