Official GIGABYTE Forum

GA-P67A-UD4-B3 Question

GA-P67A-UD4-B3 Question
« on: April 30, 2011, 08:04:03 pm »
I've recently finished assembling a desktop and I'm trying to get into the BIOS and begin setting up all the software.  When I turn the power on, all the fans including the ones on the card turn on and power flows just fine.  The Phase LED lights all light up, but after a few seconds the all go out.  Power remains, the fans continue to spin and the machine stays on, but I was wondering if the lights were supposed to stay lit or if they're suppossed to shut off after a few seconds.
GIGABYTE GA-P67A-UD4-B3 / Core i7-2600 Sandy Bridge / 2 x CORSAIR XMS 4GB 240-Pin DDR3 SDRAM DDR3 1600 / MSI N460GTX Hawk Talon Attack GeForce GTX 460 (Fermi) / Seagate Barracuda St320005N1A1AS-RK 2TB 7200 RPM SATA 6.0Gb/s

Re: GA-P67A-UD4-B3 Question
« Reply #1 on: April 30, 2011, 08:36:56 pm »
Also, I cannot get the board to POST.
GIGABYTE GA-P67A-UD4-B3 / Core i7-2600 Sandy Bridge / 2 x CORSAIR XMS 4GB 240-Pin DDR3 SDRAM DDR3 1600 / MSI N460GTX Hawk Talon Attack GeForce GTX 460 (Fermi) / Seagate Barracuda St320005N1A1AS-RK 2TB 7200 RPM SATA 6.0Gb/s

Dark Mantis

  • *
  • 18405
  • 414
  • 10typesofpeopleoneswhoknow binaryandoneswhodont
    • Dark Mantis
Re: GA-P67A-UD4-B3 Question
« Reply #2 on: April 30, 2011, 09:31:14 pm »
Hi and welcome to the Gigabyte Forum.

The LEDs are supposed to all light and then go out as POST progresses.

Have you got a buzzer installed ? If so does it make any beeps ? If not why not ? ;D

Have you installed all the power cables to the motherboard ie 24 pin, 8 pin near the CPU ?
Gigabyte X58A-UD7
i7 920
Dominators 1600 x6 12GB
6970 2GB
HX850
256GB SSD, Sam 1TB, WDB320GB
Blu-Ray
HAF 932

Gigabyte Z68X-UD5-B3
i7 3770K
Vengeance 1600 16GB
6950 2GB
HCP1200W
Revo Drive x2, 1.5TB WDB RAID0
16x DLRW
StrikeX S7
Full water cooling
3 x 27" Iiy

Re: GA-P67A-UD4-B3 Question
« Reply #3 on: May 01, 2011, 01:03:57 am »
Yes, the power supply and every other cable is connected to the board and there were no beeps, all the hardware is properly installed.  I've tried getting it to POST without any peripherals connected (that is, only the fans and the power supply plugged into the board) and nothing appears on my monitor with this configuration nor when all hardware is installed.  The LED's lighting up seem to indicate the processor is working, so I suspect the problem may be with the board itself.  Is this a logical conclusion?
GIGABYTE GA-P67A-UD4-B3 / Core i7-2600 Sandy Bridge / 2 x CORSAIR XMS 4GB 240-Pin DDR3 SDRAM DDR3 1600 / MSI N460GTX Hawk Talon Attack GeForce GTX 460 (Fermi) / Seagate Barracuda St320005N1A1AS-RK 2TB 7200 RPM SATA 6.0Gb/s

Re: GA-P67A-UD4-B3 Question
« Reply #4 on: May 01, 2011, 01:56:09 am »
check if your ram & video card are properly seated and it wouldn't hurt to re check your cpu and cooler
have you plugged in the 8 pin power cord from your psu to the motherboard

Dark Mantis

  • *
  • 18405
  • 414
  • 10typesofpeopleoneswhoknow binaryandoneswhodont
    • Dark Mantis
Re: GA-P67A-UD4-B3 Question
« Reply #5 on: May 01, 2011, 08:53:57 am »
have you plugged in the 8 pin power cord from your psu to the motherboard

We have just checked that one in the last post. ;)

Lovecat you still didn't answer my question regarding the buzzer. Do you have one installed ?
Gigabyte X58A-UD7
i7 920
Dominators 1600 x6 12GB
6970 2GB
HX850
256GB SSD, Sam 1TB, WDB320GB
Blu-Ray
HAF 932

Gigabyte Z68X-UD5-B3
i7 3770K
Vengeance 1600 16GB
6950 2GB
HCP1200W
Revo Drive x2, 1.5TB WDB RAID0
16x DLRW
StrikeX S7
Full water cooling
3 x 27" Iiy

Re: GA-P67A-UD4-B3 Question
« Reply #6 on: May 01, 2011, 10:48:40 pm »
I do not have a buzzer installed unless one comes with the motherboard.
GIGABYTE GA-P67A-UD4-B3 / Core i7-2600 Sandy Bridge / 2 x CORSAIR XMS 4GB 240-Pin DDR3 SDRAM DDR3 1600 / MSI N460GTX Hawk Talon Attack GeForce GTX 460 (Fermi) / Seagate Barracuda St320005N1A1AS-RK 2TB 7200 RPM SATA 6.0Gb/s

Dark Mantis

  • *
  • 18405
  • 414
  • 10typesofpeopleoneswhoknow binaryandoneswhodont
    • Dark Mantis
Re: GA-P67A-UD4-B3 Question
« Reply #7 on: May 02, 2011, 08:27:20 am »
In that case there is no way that you will hear any POST beeps then. :-\ I would suggets that you purchase one and fit it immediately as they cost only a few pence and can make all the difference when faultfinding.
Gigabyte X58A-UD7
i7 920
Dominators 1600 x6 12GB
6970 2GB
HX850
256GB SSD, Sam 1TB, WDB320GB
Blu-Ray
HAF 932

Gigabyte Z68X-UD5-B3
i7 3770K
Vengeance 1600 16GB
6950 2GB
HCP1200W
Revo Drive x2, 1.5TB WDB RAID0
16x DLRW
StrikeX S7
Full water cooling
3 x 27" Iiy